free portfolio site templates

Activating Hill Hold Control

When Hill Hold Control is active and the car comes to a standstill, the Hill Hold Control takes over the function of the brake pedal. You can take your foot away from the brake for 1-2 seconds. Once you press the clutch (manual transmission), or accellerator (automatic transmission), and the car wants to start moving, the brakes are released;
-It works on both manual and automatic transmision;
-Hill Hold Audi A3 8P is integrated in the ESP. So, if you do not have ESP, you can not activate Hill Hold Control;
-You do not need a button for Hill Hold. It will always be active;
-My ABS controler is ABS 1AT type:
Address 03: ABS Brakes (J104) Labels:. 1K0-907-379-60EC1F.clb
Part No SW: 1K0 907 379 BE HW: 1K0 907 379 BE
Component: ESP MK60EC1 H31 0108
Revision: 00H31001
Coding: 11422012092700FA880E04E8901A0050380800

1. 03-ABS Brakes
2. Coding - 07
3. Long Coding Helper
4. Click Byte 16
5. Enable Bit 0 (replace 0 with 1)
6. Enable Bit 1 (replace 0 with 1)
7. Exit
8. Do It!

9. Adaptation - 10
10. Select Channel 58 (Hill Hold Control)
11. Input New Value 0 or 1 or 2
12. Test, Save and Done

0 = Hill Hold Control "normal"
1 = Hill Hold Control "early" (Start with low RPMs)
2 = Hill Hold Control "late" (Start with high RPMs and slipping Clutch).

Share this page

Please note that this is only a guide and that I take no responsibility for any damage/problems. © Copyright 2019 Audi A3 8P Retrofit - All Rights Reserved